Canada's Well Water Guide
Loading regions
Yukon • 156 Registered Wells

Watson Lake Water Well Depth & Hydrogeology

Regional groundwater summary • Yukon Historical Log Extraction

Bottom Line Up Front

In Watson Lake, the median completed well is 39 ft deep.

A published hardness range for this place and aquifer is under 60 to above 180 mg/L as CaCO₃. That is a regional estimate, not a test of your well. Source: Estimate based on Health Canada hardness bands.

These municipal aggregates support planning only — they do not replace an accredited laboratory potability test for your own well.

Interactive Well Depth & Modeled Typical Strata

Drag the indicator line or tap a stratum below to read the recorded depth range

Drilling in: Sand & Gravel Aquifer (15–400+ ft)Glacial Drift Aquifer

Modelled Depth

39 FT

Area median

Drilling cost

$2,730–$5,850

Estimate

Published hardness

under 60 to above 180 mg/L as CaCO₃

0 ft (Surface)Median 39 ft400 ft (Deep)
Topsoil & Surficial Organics
Sand & Gravel Aquifer
Sand & Gravel Aquifer
Modeled typical strata:

Modeled typical strata — placeholder from median depth + aquifer type; not local driller logs.

Well Statistics

Local measurements compared against Yukon provincial benchmarks.

Total Registered Wells 156
Median Well Depth 39 ft
YT benchmark: 134 ft provincial median
Average Well Depth 52.2 ft
Hardness under 60 to above 180 mg/L as CaCO₃ — Estimate. Estimate based on Health Canada hardness bands
Drilling cost $2,730–$5,850 — Estimate. Typical drilling prices in Canada, about $70–$150 per foot
Domestic Household Use 40% of wells

Where This Report Applies

Approximate boundary of Watson Lake

Shaded area is an approximate municipal outline for orientation only. Well records are aggregated across the entire Watson Lake.

Depth Distribution

Most completed wells fall near the median depth of 39 ft. Recorded depths cover 134 wells.

0–49 ft 66.4% · 89
49–98 ft 18.7% · 25
98–148 ft 9% · 12
148–197 ft 3% · 4
197–295 ft 1.5% · 2
295–394 ft 1.5% · 2
394–591 ft 0% · 0
591+ ft 0% · 0

Median depth of 39 ft falls inside the reported range. Deeper completions here usually mean higher mineral content but steadier year-round pressure.

Aquifer Composition

Bedrock and drift aquifers recorded by drillers in this area.

188 holes found no usable water. test holes, observation or monitoring wells, dewatering wells, decommissioned wells, dry holes, no-aquifer holes, and other non-supply wells filtered out of the headline

Water Quality Profile

A published hardness range, when one exists for this place and aquifer. Not a test of your well.

Estimate

under 60 to above 180 mg/L as CaCO₃

Estimate. Estimate based on Health Canada hardness bands. Regional estimate, not a test of your well.

Health Canada. Guidelines for Canadian Drinking Water Quality: Operational Parameters.

No measured government test within 25 km. Test your water.

Soft (<60) Med (61–120) Hard (121–180) V. hard (>180)

USGS (2018) bands reprinted by Health Canada. A range can cross more than one band. This is not a sample.

What this is not

  • Not a laboratory result for a well on your property.
  • Not a reason to size a softener. Size equipment from a lab test.
  • Not a drilling quote. A cost line on this page is a national estimate, not a price for one well.

Health Canada has not set a maximum acceptable concentration for hardness. A wide published range can sit in more than one USGS band.

Drilling Activity

Historical permit and construction activity by decade.

Pre-1970 1 wells
1970s 46 wells
1980s 53 wells
1990s 26 wells
2000s 13 wells
2010s 101 wells
2020s 64 wells

Treatment

Size treatment from a laboratory test

This page does not turn a hardness range or a well depth into an equipment total, a grain capacity, or a drilling price. Read the methodology, the filtration guide, and the products catalog.

Suggested system

Suggested system for Watson Lake

1

Test kit

estimate, confirm with a lab test

A test of your own well comes before any equipment. Test for coliform bacteria.

Water testing
Local Contractors

Licensed Water Well Drillers Serving Watson Lake

Because water wells in Watson Lake average 39 ft, contractors equipped with heavy rotary rigs and proper casing seals are recommended. Contact local drillers directly or request competitive bids.

Northwell Drilling

Yard: Whitehorse, YT (356.9 km away)

Serves Watson Lake
Confirm the contractor's provincial licence before you hire
Homestead & Acreage Wells Well Rehabilitation Submersible Pumps

Midnight Sun Drilling Inc.

Yard: Whitehorse, YT (354.3 km away)

Confirm the contractor's provincial licence before you hire
Northern Domestic Wells Deep Bedrock Casing Geothermal Loops

New Age Drilling Solutions

Yard: Whitehorse, YT (355.4 km away)

Confirm the contractor's provincial licence before you hire
Environmental & Water Wells Geotechnical Rigs Pump Servicing

Vision Quest Drilling Inc.

Yard: Whitehorse, YT (357 km away)

Confirm the contractor's provincial licence before you hire
Mineral & Water Drilling Exploratory Boreholes Remote Camps

Looking for more regional well drillers?

Explore all registered water well contractors operating across YT.

Featured Contractor Spot

Are you a licensed well driller serving Watson Lake?

Claim your verified listing profile and be found by homeowners on this report.

Claim Local Listing

Frequently Asked Questions

Quick answers about water wells in Watson Lake.

What is the median well depth in yt-watson-lake?

Among 134 producing water wells with a recorded depth, the median is 39.4 ft (11.994 m).

Adjacent Municipalities & Nearby Well Records

Explore neighbouring hydrogeological formations and compare drilling depths