Fraser Valley Water Well Depth & Hydrogeology
Regional groundwater summary • GWDrill Historical Log Extraction
Bottom Line Up Front
In Fraser Valley the median well is 45 feet deep and draws from Sand & Gravel Drift bedrock, which supplies 3.2% of wells here. Water is very hard at about 325 mg/L, so a softener is standard equipment. Rotary drilling is routine and 94% of wells serve ordinary household use. Treatment emphasis: sediment turbidity, localized iron/manganese. Unconsolidated sediments demand particulate intrusion monitoring.
Modelled Well Depth
45 FT
Median for this area. Typical range 21–78 ft.
Est. Completion Cost
$5,320 CAD
$118/ft effective rate (includes fixed $1,900 mobilization & pump installation).
Water Hardness
325 MG/L
Very Hard. Sediment turbidity, localized iron/manganese.
Pump class at this depth: 1/2 HP submersible, 4" casing
Adjust Target Depth
Drag the yellow indicator across the strata bar
Well Statistics
Local measurements compared against British Columbia provincial benchmarks.
| Hydrogeological Metric | Local Measurement | BC Provincial Benchmark |
|---|---|---|
| Total Registered Wells | 93 | 1,420 avg per RM |
| Median Well Depth | 45 ft | 118 ft provincial median |
| Average Well Depth | 64.0 ft | 137.1 ft provincial average |
| Recorded Depth Range | 6 – 300 ft | 2 – 1,201 ft recorded range |
| Dominant Aquifer | Sand & Gravel Drift | Mixed glacial till province-wide |
| Estimated Water Hardness | 325 mg/L — Very Hard | 210 mg/L provincial average |
| Est. Drilling Cost Range | $6,610 – $17,260 CAD | $110/ft plus mobilization |
| Domestic Household Use | 94% of wells | 88% province-wide |
Where This Report Applies
Approximate boundary of Fraser Valley
Shaded area is an approximate municipal outline for orientation only. Well records are aggregated across the entire Fraser Valley.
Depth Distribution
Most completed wells fall near the median depth of 45 ft.
Median depth of 45 ft falls inside the reported range. Deeper completions here usually mean higher mineral content but steadier year-round pressure.
Aquifer Composition
Bedrock and drift aquifers recorded by drillers in this area.
3 wells Unclassified hydrogeological formation from legacy provincial drill records.
Water Quality Profile
Estimated hardness, mineral risks and treatment implications.
Total Hardness
Very Hard325 MG/L
as CaCO3, Health Canada scale
Present Mineral Risk
- Scale build-up in kettles, heaters and fixtures
- Dissolved iron and manganese staining
- Elevated calcium and magnesium from Sand & Gravel Drift bedrock
Test before purchasing treatment. Hardness varies well to well within the same quarter section.
Size custom treatment system for this waterDrilling Activity
Historical permit and construction activity by decade.
100% of wells are over 30 years old. Steel casing installed before 1995 can lose integrity, so any older well should get a casing inspection and a bacterial test before you rely on it.
Data-Driven Prescription
The treatment system this water needs
Generated from 325 mg/L hardness, sand & gravel drift and a 45 ft median completion depth, for a four-person household. Adjust the assumptions in the builder.
Equipment Total
$3,337
Annual Consumables
$609
Softener Sizing
52,000 gr
Water Testing
Tap Score Canadian Essential Water Test
Nothing gets sized without numbers. Regional modelling puts hardness near 325 mg/L in sand & gravel drift, but your own well can sit well off that median.
- Sizing
- Accredited lab panel: hardness, iron, manganese, nitrate, arsenic, total coliform and E. coli
- Equipment
- $349 CAD
- Annual Consumables
- $349 CAD
Sediment Prefilter
SpringWell Whole-House Spin-Down Sediment Filter
Sand & Gravel Drift aquifers carry fine sand and turbidity that destroys softener resin and UV lamp clarity.
- Sizing
- Full-flow prefilter, 20 micron, ahead of all treatment
- Equipment
- $749 CAD
- Annual Consumables
- None
Whole-Home Softening
SpringWell SS1 48,000 Grain Whole-Home Softener
At 325 mg/L (very hard) a 4-person household loads roughly 5.7k grains of hardness per day onto the plumbing.
- Sizing
- 52,000 grain metered capacity — about a 7-day regeneration cycle with reserve
- Equipment
- $1,690 CAD
- Annual Consumables
- $140 CAD
UV Disinfection
iSpring UVF55FS 12 GPM Whole-House UV Disinfection System
Median completion depth of 45 ft in sand & gravel drift leaves this aquifer surface-influenced, which is where coliform hits come from.
- Sizing
- 12 GPM UV, installed last in the treatment train, downstream of all filtration
- Equipment
- $549 CAD
- Annual Consumables
- $120 CAD
Featured Contractor Spot
Are you a licensed well driller serving Fraser Valley?
Claim your verified listing profile and be found by homeowners on this report.
Instant WellCheck™ Property Dossier
Buying rural acreage or a home in Fraser Valley? Get an automated 12-page comprehensive property report analyzing all adjacent well logs, lithology strata, aquifer vulnerability, pump test yields, and water hardness risks.
Planning to Drill?
Get three free drilling quotes
Matched to contractors who already drill in Fraser Valley. Compare casing sizes, depth guarantees, and mobilization fees.
Frequently Asked Questions
Quick answers about water wells in Fraser Valley.
How deep are water wells in Fraser Valley?
The average water well in Fraser Valley, BC is 64.0 feet deep. Most wells range between 21.0 and 78.0 feet.
What is the primary aquifer in Fraser Valley?
The most common aquifer tapped by drillers in Fraser Valley is Sand & Gravel Drift.