Regional groundwater summary • British Columbia Historical Log Extraction
Bottom Line Up Front
In Surrey, the median completed well is 170 ft deep.
A published hardness range for this place and aquifer is less than 10 to 180, and groundwater can exceed 1,000 mg/L as CaCO₃. That is a regional estimate, not a test of your well. Source: Estimate based on B.C. Ministry of Environment water-quality checks.
Most production draws from Unconsolidated (about 58% of local wells).
These municipal aggregates support planning only — they do not replace an accredited laboratory potability test for your own well.
Interactive Well Depth & Modeled Typical Strata
Drag the indicator line or tap a stratum below to read the recorded depth range
Modelled Depth
170 FT
Area median
Drilling cost
$11,900–$25,500
Estimate
Published hardness
less than 10 to 180, and groundwater can exceed 1,000 mg/L as CaCO₃
Modeled typical strata — placeholder from median depth + aquifer type; not local driller logs.
Local measurements compared against British Columbia provincial benchmarks.
| Hydrogeological Metric | From the registry or a cited study | BC Provincial Benchmark |
|---|---|---|
| Total Registered Wells | 549 | — |
| Median Well Depth | 170 ft | 162 ft provincial median |
| Average Well Depth | 190.4 ft | — |
| Dominant Aquifer | Unconsolidated | — |
| Hardness | less than 10 to 180, and groundwater can exceed 1,000 mg/L as CaCO₃ — Estimate. Estimate based on B.C. Ministry of Environment water-quality checks | — |
| Drilling cost | $11,900–$25,500 — Estimate. Typical drilling prices in Canada, about $70–$150 per foot | — |
| Domestic Household Use | 78% of wells | — |
Approximate boundary of Surrey
Shaded area is an approximate municipal outline for orientation only. Well records are aggregated across the entire Surrey.
Most completed wells fall near the median depth of 170 ft. Recorded depths cover 528 wells.
Median depth of 170 ft falls inside the reported range. Deeper completions here usually mean higher mineral content but steadier year-round pressure.
Bedrock and drift aquifers recorded by drillers in this area. Recorded for 317 of these 549 wells.
317 of 549 Unclassified hydrogeological formation from legacy provincial drill records.
174 holes found no usable water. test holes, observation or monitoring wells, dewatering wells, decommissioned wells, dry holes, no-aquifer holes, and other non-supply wells filtered out of the headline
A published hardness range, when one exists for this place and aquifer. Not a test of your well.
Measured nearby
Measured government tests within 25 km of Surrey.
USGS (2018) bands reprinted by Health Canada. A range can cross more than one band. This is not a sample.
What this is not
Health Canada has not set a maximum acceptable concentration for hardness. A wide published range can sit in more than one USGS band.
OBS WELL 275 - SURREY (36TH AVE NEAR 194TH ST), 5.9 km away, nearby.
31 government lab tests, dated 1988–2017.
Hardness 17–177 mg/L as CaCO₃, median 75.
Worked out by wellwaterguide.ca from 31 government lab tests.
reported hardness, or calculated from measured calcium and magnesium when hardness was not reported
BC Environmental Monitoring Data System (EnMoDS) results: Provincial Groundwater Observation Well Network wells Open Government Licence - British Columbia
OBS WELL 353 - LANGLEY, 6.17 km away, nearby.
32 government lab tests, dated 2004–2017.
Hardness 63–122 mg/L as CaCO₃, median 78.6.
Worked out by wellwaterguide.ca from 32 government lab tests.
reported hardness, or calculated from measured calcium and magnesium when hardness was not reported
BC Environmental Monitoring Data System (EnMoDS) results: Provincial Groundwater Observation Well Network wells Open Government Licence - British Columbia
OBS WELL 360 - LANGLEY, 8.79 km away, nearby.
22 government lab tests, dated 2005–2022.
Hardness 49–96 mg/L as CaCO₃, median 56.6.
Worked out by wellwaterguide.ca from 22 government lab tests.
reported hardness, or calculated from measured calcium and magnesium when hardness was not reported
BC Environmental Monitoring Data System (EnMoDS) results: Provincial Groundwater Observation Well Network wells Open Government Licence - British Columbia
11 wells tested, range 5–241 mg/L.
1.33 km away, nearby.
Tests dated 1992–2025.
1 well tests above 180 mg/L.
Worked out by wellwaterguide.ca from 22 government lab tests.
reported hardness, or calculated from measured calcium and magnesium when hardness was not reported
BC Environmental Monitoring Data System (EnMoDS) results: Provincial Groundwater Observation Well Network wells Open Government Licence - British Columbia
Historical permit and construction activity by decade.
Treatment
This page does not turn a hardness range or a well depth into an equipment total, a grain capacity, or a drilling price. Read the methodology, the filtration guide, and the products catalog.
Suggested system
Test kit
estimate, confirm with a lab testA test of your own well comes before any equipment. Test for coliform bacteria.
Water testingSediment prefilter
estimate, confirm with a lab testA sediment prefilter is worth considering where wells draw from Unconsolidated. This follows the aquifer type.
Sediment guideIron and manganese filter
estimate, confirm with a lab testManganese above the aesthetic objective, consider an iron/manganese filter. One monitoring well near this place has median manganese of 0.0846 mg/L. Another has median manganese of 0.0295 mg/L. Another has median iron of 0.614 mg/L and median manganese of 0.0952 mg/L.
Iron and manganese guideUV disinfection
estimate, confirm with a lab testUV disinfection is worth considering where wells draw from Unconsolidated. Test for coliform bacteria. This follows the aquifer type.
Bacteria and UV guideBecause water wells in Surrey average 170 ft into unconsolidated, contractors equipped with heavy rotary rigs and proper casing seals are recommended. Contact local drillers directly or request competitive bids.
Yard: Abbotsford, BC (29.8 km away)
Yard: Chilliwack, BC (62.2 km away)
Yard: Duncan, BC (80 km away)
Yard: Cumberland, BC (175.3 km away)
Looking for more regional well drillers?
Explore all registered water well contractors operating across BC.
Featured Contractor Spot
Claim your verified listing profile and be found by homeowners on this report.
Quick answers about water wells in Surrey.
Among 528 producing water wells with a recorded depth, the median is 170.0 ft (51.82 m).
The most frequently recorded producing aquifer is Unconsolidated, on 317 of 317 wells with a producing aquifer name.
Explore neighbouring hydrogeological formations and compare drilling depths