Test kit
estimate, confirm with a lab testA test of your own well comes before any equipment. Test for coliform bacteria.
Water testingRegional groundwater summary • GWDrill Historical Log Extraction
Bottom Line Up Front
In Cartwright-Roblin Municipality, the median completed well is 120 ft deep.
A published hardness range for this place and aquifer is 50 to greater than 1,000 mg/L as CaCO₃. That is a regional estimate, not a test of your well. Source: Estimate based on Manitoba Water Stewardship. Birdtail / Assiniboine West (05ME) groundwater resources..
Most production draws from SHALE (about 53% of local wells).
These municipal aggregates support planning only — they do not replace an accredited laboratory potability test for your own well.
Interactive Well Depth & Geological Stratigraphy (From Local Driller Logs)
Drag the indicator line or tap a geological stratum below to read the recorded depth range
Modelled Depth
120 FT
Area median
Drilling cost
$8,400–$18,000
Estimate
Published hardness
50 to greater than 1,000 mg/L as CaCO₃
From local driller logs.
Local measurements compared against Manitoba provincial benchmarks.
| Hydrogeological Metric | From the registry or a cited study | MB Provincial Benchmark |
|---|---|---|
| Total Registered Wells | 554 | — |
| Median Well Depth | 120 ft | 88 ft provincial median |
| Average Well Depth | 126.0 ft | — |
| Recorded Depth Range | 11 – 407 ft | — |
| Dominant Aquifer | SHALE | — |
| Hardness | 50 to greater than 1,000 mg/L as CaCO₃ — Estimate. Estimate based on Manitoba Water Stewardship. Birdtail / Assiniboine West (05ME) groundwater resources. | — |
| Drilling cost | $8,400–$18,000 — Estimate. Typical drilling prices in Canada, about $70–$150 per foot | — |
| Domestic Household Use | 0% of wells | — |
Approximate boundary of Cartwright-Roblin Municipality
Shaded area is an approximate municipal outline for orientation only. Well records are aggregated across the entire Cartwright-Roblin Municipality.
Most completed wells fall near the median depth of 120 ft. Recorded depths cover 521 wells.
Median depth of 120 ft falls inside the reported range. Deeper completions here usually mean higher mineral content but steadier year-round pressure.
Bedrock and drift aquifers recorded by drillers in this area.
293 of 554 Fractured sedimentary shale formation (including Odanah / Pierre members). Characterized by high total dissolved solids (TDS) and potential sulfur/iron compounds.
215 of 554 Shallow to intermediate glacial drift aquifer deposited in alluvial channels or outwash plains. Yields softer water but requires continuous sediment filtration and shallow bacterial monitoring.
44 of 554 Unclassified hydrogeological formation from legacy provincial drill records.
2 of 554 Dense, low-permeability clay-rich glacial deposits with localized silt lenses. Serves as a natural confining barrier protecting deeper aquifers from surface contamination.
90 holes found no usable water. test holes, observation or monitoring wells, dewatering wells, decommissioned wells, dry holes, no-aquifer holes, and other non-supply wells filtered out of the headline
A published hardness range, when one exists for this place and aquifer. Not a test of your well.
Estimate
50 to greater than 1,000 mg/L as CaCO₃
Estimate. Estimate based on Manitoba Water Stewardship. Birdtail / Assiniboine West (05ME) groundwater resources.. Regional estimate, not a test of your well.
Manitoba Water Stewardship. Birdtail / Assiniboine West (05ME) groundwater resources.
No measured government test within 25 km. Test your water.
USGS (2018) bands reprinted by Health Canada. A range can cross more than one band. This is not a sample.
What this is not
Health Canada has not set a maximum acceptable concentration for hardness. A wide published range can sit in more than one USGS band.
Historical permit and construction activity by decade.
67% of dated wells are over 30 years old (pre-1995). Steel casing installed before 1995 can lose integrity over time. Any older well should get a casing inspection and a certified bacterial test before reliance.
Treatment
This page does not turn a hardness range or a well depth into an equipment total, a grain capacity, or a drilling price. Read the methodology, the filtration guide, and the products catalog.
Suggested system
Test kit
estimate, confirm with a lab testA test of your own well comes before any equipment. Test for coliform bacteria.
Water testingBecause water wells in Cartwright-Roblin Municipality average 120 ft into shale, contractors equipped with heavy rotary rigs and proper casing seals are recommended. Contact local drillers directly or request competitive bids.
Yard: Brandon, MB (97.6 km away)
Yard: Neepawa, MB (124.6 km away)
Yard: Headingley, MB (159.7 km away)
Yard: Warren, MB (166.5 km away)
Looking for more regional well drillers?
Explore all registered water well contractors operating across MB.
Featured Contractor Spot
Claim your verified listing profile and be found by homeowners on this report.
Quick answers about water wells in Cartwright-Roblin Municipality.
Among 521 producing water wells with a recorded depth, the median is 120.0 ft (36.576 m).
The most frequently recorded producing aquifer is SHALE, on 293 of 554 wells with a producing aquifer name.
Explore neighbouring hydrogeological formations and compare drilling depths