Canada's Well Water Guide
Loading regions
Manitoba • 268 Registered Wells

City of Brandon Water Well Depth & Hydrogeology

Regional groundwater summary • GWDrill Historical Log Extraction

Bottom Line Up Front

In City of Brandon, the median completed well is 40 ft deep.

A published hardness range for this place and aquifer is under 60 to above 180 mg/L as CaCO₃. That is a regional estimate, not a test of your well. Source: Estimate based on Health Canada hardness bands.

Most production draws from SAND AND GRAVEL (about 85% of local wells).

These municipal aggregates support planning only — they do not replace an accredited laboratory potability test for your own well.

Interactive Well Depth & Geological Stratigraphy (From Local Driller Logs)

Drag the indicator line or tap a geological stratum below to read the recorded depth range

Drilling in: Glacial Drift Silt & Till (10–60 ft)Protective Overburden

Modelled Depth

40 FT

Area median

Drilling cost

$2,800–$6,000

Estimate

Published hardness

under 60 to above 180 mg/L as CaCO₃

0 ft (Surface)Median 40 ft430 ft (Deep)
Glacial Lacustrine Clay & Silt
Glacial Drift Silt & Till
Sand & Gravel Aquifer
Sedimentary Shale Formation
From local driller logs:

From local driller logs.

Well Statistics

Local measurements compared against Manitoba provincial benchmarks.

Total Registered Wells 268
Median Well Depth 40 ft
MB benchmark: 88 ft provincial median
Average Well Depth 60.4 ft
Recorded Depth Range 2 – 346 ft
Dominant Aquifer SAND AND GRAVEL
Hardness under 60 to above 180 mg/L as CaCO₃ — Estimate. Estimate based on Health Canada hardness bands
Drilling cost $2,800–$6,000 — Estimate. Typical drilling prices in Canada, about $70–$150 per foot
Domestic Household Use 0% of wells

Where This Report Applies

Approximate boundary of City of Brandon

Shaded area is an approximate municipal outline for orientation only. Well records are aggregated across the entire City of Brandon.

Depth Distribution

Most completed wells fall near the median depth of 40 ft. Recorded depths cover 264 wells.

0–49 ft 64.4% · 170
49–98 ft 23.9% · 63
98–148 ft 3% · 8
148–197 ft 2.7% · 7
197–295 ft 2.3% · 6
295–394 ft 3.8% · 10
394–591 ft 0% · 0
591+ ft 0% · 0

Median depth of 40 ft falls inside the reported range. Deeper completions here usually mean higher mineral content but steadier year-round pressure.

Aquifer Composition

Bedrock and drift aquifers recorded by drillers in this area.

Sand & Gravel Aquifer Glacial Drift Aquifer
84.7%

227 of 268 Shallow to intermediate glacial drift aquifer deposited in alluvial channels or outwash plains. Yields softer water but requires continuous sediment filtration and shallow bacterial monitoring.

Undifferentiated Aquifer Regional Formation
8.2%

22 of 268 Unclassified hydrogeological formation from legacy provincial drill records.

Glacial Drift Silt & Till Protective Overburden
4.5%

12 of 268 Dense, low-permeability clay-rich glacial deposits with localized silt lenses. Serves as a natural confining barrier protecting deeper aquifers from surface contamination.

Sedimentary Shale Formation Fractured Shale Aquifer
2.2%

6 of 268 Fractured sedimentary shale formation (including Odanah / Pierre members). Characterized by high total dissolved solids (TDS) and potential sulfur/iron compounds.

Carbonate Bedrock (Limestone / Dolomite) Primary Bedrock Aquifer
0.4%

1 of 268 Major regional bedrock aquifer formed by Ordovician/Silurian dolomite. Known for reliable, high-volume yields with elevated mineral hardness and dissolved calcium/magnesium carbonates.

367 holes found no usable water. test holes, observation or monitoring wells, dewatering wells, decommissioned wells, dry holes, no-aquifer holes, and other non-supply wells filtered out of the headline

Water Quality Profile

A published hardness range, when one exists for this place and aquifer. Not a test of your well.

Estimate

under 60 to above 180 mg/L as CaCO₃

Estimate. Estimate based on Health Canada hardness bands. Regional estimate, not a test of your well.

Health Canada. Guidelines for Canadian Drinking Water Quality: Operational Parameters.

No measured government test within 25 km. Test your water.

Soft (<60) Med (61–120) Hard (121–180) V. hard (>180)

USGS (2018) bands reprinted by Health Canada. A range can cross more than one band. This is not a sample.

What this is not

  • Not a laboratory result for a well on your property.
  • Not a reason to size a softener. Size equipment from a lab test.
  • Not a drilling quote. A cost line on this page is a national estimate, not a price for one well.

Health Canada has not set a maximum acceptable concentration for hardness. A wide published range can sit in more than one USGS band.

Drilling Activity

Historical permit and construction activity by decade.

Pre-1970 22 wells · avg 71 ft
1970s 41 wells · avg 54 ft
1980s 50 wells · avg 56 ft
1990s 28 wells · avg 92 ft
2000s 36 wells · avg 55 ft
2010s 31 wells · avg 58 ft
2020s 13 wells · avg 76 ft

56% of dated wells are over 30 years old (pre-1995). Steel casing installed before 1995 can lose integrity over time. Any older well should get a casing inspection and a certified bacterial test before reliance.

Treatment

Size treatment from a laboratory test

This page does not turn a hardness range or a well depth into an equipment total, a grain capacity, or a drilling price. Read the methodology, the filtration guide, and the products catalog.

Suggested system

Suggested system for City of Brandon

1

Test kit

estimate, confirm with a lab test

A test of your own well comes before any equipment. Test for coliform bacteria.

Water testing
2

Sediment prefilter

estimate, confirm with a lab test

A sediment prefilter is worth considering where wells draw from SAND AND GRAVEL. This follows the aquifer type.

Sediment guide
3

UV disinfection

estimate, confirm with a lab test

UV disinfection is worth considering where wells draw from SAND AND GRAVEL. Test for coliform bacteria. This follows the aquifer type.

Bacteria and UV guide
Local Contractors

Licensed Water Well Drillers Serving City of Brandon

Because water wells in City of Brandon average 40 ft into sand and gravel, contractors equipped with heavy rotary rigs and proper casing seals are recommended. Contact local drillers directly or request competitive bids.

Fred A. Zavislak Well Drilling Ltd.

Yard: Brandon, MB (5.1 km away)

★ 4.5 (8 Google reviews)
Westman Drilled Wells Deep Sand Screens Residential Acreages

Rob Smith & Son Drilling

Yard: Neepawa, MB (54.5 km away)

Confirm the contractor's provincial licence before you hire
Riding Mountain Slopes Delta Sand Aquifers Farm & Acreage Supply

Formation Drilling Ltd.

Yard: Dauphin, MB (145.3 km away)

Confirm the contractor's provincial licence before you hire
Parkland Hydrogeology Artesian Flow Control Glacial Drift Screens

MacKay Drilling & Pumps

Yard: Warren, MB (169.7 km away)

Confirm the contractor's provincial licence before you hire
Submersible Pumps Pressure Tanks Bedrock Casing

Looking for more regional well drillers?

Explore all registered water well contractors operating across MB.

Featured Contractor Spot

Are you a licensed well driller serving City of Brandon?

Claim your verified listing profile and be found by homeowners on this report.

Claim Local Listing

Frequently Asked Questions

Quick answers about water wells in City of Brandon.

What is the median well depth in City of Brandon?

Among 264 producing water wells with a recorded depth, the median is 39.5 ft (12.0396 m).

Which aquifer is recorded most often in City of Brandon?

The most frequently recorded producing aquifer is SAND AND GRAVEL, on 227 of 268 wells with a producing aquifer name.

Adjacent Municipalities & Nearby Well Records

Explore neighbouring hydrogeological formations and compare drilling depths

Nearby communities