RM OF SIFTON Water Well Depth & Hydrogeology
Regional groundwater summary • GWDrill Historical Log Extraction
Bottom Line Up Front
In RM OF SIFTON the median well is 32 feet deep and draws from Sand and Gravel Aquifer bedrock, which supplies 81.8% of wells here. Water is very hard at about 234 mg/L, so a softener is standard equipment. Rotary drilling is routine and 75.8% of wells serve ordinary household use. Treatment emphasis: sediment turbidity, localized iron/manganese. Unconsolidated sediments demand particulate intrusion monitoring.
Modelled Well Depth
32 FT
Median for this area. Typical range 25–50 ft.
Est. Completion Cost
$4,940 CAD
$154/ft effective rate (includes fixed $1,900 mobilization & pump installation).
Water Hardness
234 MG/L
Very Hard. Sediment turbidity, localized iron/manganese.
Pump class at this depth: 1/2 HP submersible, 4" casing
Adjust Target Depth
Drag the yellow indicator across the strata bar
Well Statistics
Local measurements compared against Manitoba provincial benchmarks.
| Hydrogeological Metric | Local Measurement | MB Provincial Benchmark |
|---|---|---|
| Total Registered Wells | 851 | 1,420 avg per RM |
| Median Well Depth | 32 ft | 118 ft provincial median |
| Average Well Depth | 51.9 ft | 137.1 ft provincial average |
| Recorded Depth Range | 1 – 435 ft | 2 – 1,201 ft recorded range |
| Dominant Aquifer | Sand and Gravel Aquifer | Mixed glacial till province-wide |
| Estimated Water Hardness | 234 mg/L — Very Hard | 210 mg/L provincial average |
| Est. Drilling Cost Range | $5,200 – $13,000 CAD | $110/ft plus mobilization |
| Domestic Household Use | 76% of wells | 88% province-wide |
Where This Report Applies
Approximate boundary of RM OF SIFTON
Shaded area is an approximate municipal outline for orientation only. Well records are aggregated across the entire RM OF SIFTON.
Depth Distribution
Most completed wells fall near the median depth of 32 ft.
Median depth of 32 ft falls inside the reported range. Deeper completions here usually mean higher mineral content but steadier year-round pressure.
Aquifer Composition
Bedrock and drift aquifers recorded by drillers in this area.
696 wells Shallow to intermediate glacial drift aquifer deposited in alluvial channels or outwash plains. Yields softer water but requires continuous sediment filtration and shallow bacterial monitoring.
91 wells Unclassified hydrogeological formation from legacy provincial drill records.
38 wells Low-permeability clay-rich glacial deposits with localized sand lenses. Often slow recharge.
26 wells Fractured Cretaceous shale formation prominent in western Manitoba. Characterized by high total dissolved solids (TDS) and potential sulfur/iron compounds.
Water Quality Profile
Estimated hardness, mineral risks and treatment implications.
Total Hardness
Very Hard234 MG/L
as CaCO3, Health Canada scale
Present Mineral Risk
- Scale build-up in kettles, heaters and fixtures
- Dissolved iron and manganese staining
- Elevated calcium and magnesium from Sand and Gravel Aquifer bedrock
Test before purchasing treatment. Hardness varies well to well within the same quarter section.
Size custom treatment system for this waterDrilling Activity
Historical permit and construction activity by decade.
38% of wells are over 30 years old. Steel casing installed before 1995 can lose integrity, so any older well should get a casing inspection and a bacterial test before you rely on it.
Data-Driven Prescription
The treatment system this water needs
Generated from 234 mg/L hardness, sand and gravel aquifer and a 32 ft median completion depth, for a four-person household. Adjust the assumptions in the builder.
Equipment Total
$1,988
Annual Consumables
$579
Softener Sizing
37,000 gr
Water Testing
Tap Score Canadian Essential Water Test
Nothing gets sized without numbers. Regional modelling puts hardness near 234 mg/L in sand and gravel aquifer, but your own well can sit well off that median.
- Sizing
- Accredited lab panel: hardness, iron, manganese, nitrate, arsenic, total coliform and E. coli
- Equipment
- $349 CAD
- Annual Consumables
- $349 CAD
Whole-Home Softening
Fleck 5600SXT 32,000 Grain High-Efficiency Softener
At 234 mg/L (very hard) a 4-person household loads roughly 4.1k grains of hardness per day onto the plumbing.
- Sizing
- 37,000 grain metered capacity — about a 7-day regeneration cycle with reserve
- Equipment
- $1,090 CAD
- Annual Consumables
- $110 CAD
UV Disinfection
iSpring UVF55FS 12 GPM Whole-House UV Disinfection System
Median completion depth of 32 ft in sand and gravel aquifer leaves this aquifer surface-influenced, which is where coliform hits come from.
- Sizing
- 12 GPM UV, installed last in the treatment train, downstream of all filtration
- Equipment
- $549 CAD
- Annual Consumables
- $120 CAD
Featured Contractor Spot
Are you a licensed well driller serving RM OF SIFTON?
Claim your verified listing profile and be found by homeowners on this report.
Instant WellCheck™ Property Dossier
Buying rural acreage or a home in RM OF SIFTON? Get an automated 12-page comprehensive property report analyzing all adjacent well logs, lithology strata, aquifer vulnerability, pump test yields, and water hardness risks.
Planning to Drill?
Get three free drilling quotes
Matched to contractors who already drill in RM OF SIFTON. Compare casing sizes, depth guarantees, and mobilization fees.
Frequently Asked Questions
Quick answers about water wells in RM OF SIFTON.
How deep are water wells in RM OF SIFTON?
The average water well in RM OF SIFTON, MB is 51.9 feet deep. Most wells range between 25.0 and 50.0 feet.
What is the primary aquifer in RM OF SIFTON?
The most common aquifer tapped by drillers in RM OF SIFTON is SAND AND GRAVEL.