Canada's Well Water Guide
Loading regions
British Columbia • 140 Registered Wells

Spallumcheen Water Well Depth & Hydrogeology

Regional groundwater summary • British Columbia Historical Log Extraction

Bottom Line Up Front

In Spallumcheen, the median completed well is 199 ft deep.

A published hardness range for this place and aquifer is less than 10 to 180, and groundwater can exceed 1,000 mg/L as CaCO₃. That is a regional estimate, not a test of your well. Source: Estimate based on B.C. Ministry of Environment water-quality checks.

Most production draws from Unconsolidated (about 31% of local wells).

These municipal aggregates support planning only — they do not replace an accredited laboratory potability test for your own well.

Interactive Well Depth & Modeled Typical Strata

Drag the indicator line or tap a stratum below to read the recorded depth range

Drilling in: Sand & Gravel Aquifer (41–470+ ft)Glacial Drift Aquifer

Modelled Depth

199 FT

Area median

Drilling cost

$13,930–$29,850

Estimate

Published hardness

less than 10 to 180, and groundwater can exceed 1,000 mg/L as CaCO₃

0 ft (Surface)Median 199 ft470 ft (Deep)
Topsoil & Surficial Organics
Glacial Drift Silt & Till
Sand & Gravel Aquifer
Modeled typical strata:

Modeled typical strata — placeholder from median depth + aquifer type; not local driller logs.

Well Statistics

Local measurements compared against British Columbia provincial benchmarks.

Total Registered Wells 140
Median Well Depth 199 ft
BC benchmark: 162 ft provincial median
Average Well Depth 225.9 ft
Dominant Aquifer Unconsolidated
Hardness less than 10 to 180, and groundwater can exceed 1,000 mg/L as CaCO₃ — Estimate. Estimate based on B.C. Ministry of Environment water-quality checks
Drilling cost $13,930–$29,850 — Estimate. Typical drilling prices in Canada, about $70–$150 per foot
Domestic Household Use 44% of wells

Where This Report Applies

Approximate boundary of Spallumcheen

Shaded area is an approximate municipal outline for orientation only. Well records are aggregated across the entire Spallumcheen.

Depth Distribution

Most completed wells fall near the median depth of 199 ft. Recorded depths cover 137 wells.

0–49 ft 9.5% · 13
49–98 ft 10.2% · 14
98–148 ft 11.7% · 16
148–197 ft 16.1% · 22
197–295 ft 28.5% · 39
295–394 ft 10.9% · 15
394–591 ft 9.5% · 13
591+ ft 3.6% · 5

Median depth of 199 ft falls inside the reported range. Deeper completions here usually mean higher mineral content but steadier year-round pressure.

Aquifer Composition

Bedrock and drift aquifers recorded by drillers in this area. Recorded for 57 of these 140 wells.

Undifferentiated Aquifer Regional Formation
31.4%

44 of 140 Unclassified hydrogeological formation from legacy provincial drill records.

Carbonate Bedrock (Limestone / Dolomite) Primary Bedrock Aquifer
9.3%

13 of 140 Major regional bedrock aquifer formed by Ordovician/Silurian dolomite. Known for reliable, high-volume yields with elevated mineral hardness and dissolved calcium/magnesium carbonates.

10 holes found no usable water. test holes, observation or monitoring wells, dewatering wells, decommissioned wells, dry holes, no-aquifer holes, and other non-supply wells filtered out of the headline

Water Quality Profile

A published hardness range, when one exists for this place and aquifer. Not a test of your well.

Measured nearby

Measured government tests within 25 km of Spallumcheen.

Soft (<60) Med (61–120) Hard (121–180) V. hard (>180)

USGS (2018) bands reprinted by Health Canada. A range can cross more than one band. This is not a sample.

What this is not

  • Not a laboratory result for a well on your property.
  • Not a reason to size a softener. Size equipment from a lab test.
  • Not a drilling quote. A cost line on this page is a national estimate, not a price for one well.

Health Canada has not set a maximum acceptable concentration for hardness. A wide published range can sit in more than one USGS band.

OBS WELL 117 - ARMSTRONG (OTTER LAKE CROSS RD.), 3.93 km away, nearby.

5 government lab tests, dated 1985–2009.

These results are old (tested 1985–2009).

Hardness 148–170 mg/L as CaCO₃, median 152.6.

Worked out by wellwaterguide.ca from 5 government lab tests.

reported hardness, or calculated from measured calcium and magnesium when hardness was not reported

BC Environmental Monitoring Data System (EnMoDS) results: Provincial Groundwater Observation Well Network wells Open Government Licence - British Columbia

Drilling Activity

Historical permit and construction activity by decade.

Pre-1970 6 wells
1970s 7 wells
1980s 19 wells
1990s 15 wells
2000s 18 wells
2010s 23 wells
2020s 28 wells

Treatment

Size treatment from a laboratory test

This page does not turn a hardness range or a well depth into an equipment total, a grain capacity, or a drilling price. Read the methodology, the filtration guide, and the products catalog.

Suggested system

Suggested system for Spallumcheen

1

Test kit

estimate, confirm with a lab test

A test of your own well comes before any equipment. Test for coliform bacteria.

Water testing
2

Sediment prefilter

estimate, confirm with a lab test

A sediment prefilter is worth considering where wells draw from Unconsolidated. This follows the aquifer type.

Sediment guide
3

Iron and manganese filter

estimate, confirm with a lab test

Manganese above the aesthetic objective, consider an iron/manganese filter. One monitoring well near this place has median manganese of 0.022 mg/L. Another has median iron of 1.65 mg/L and median manganese of 0.124 mg/L.

Iron and manganese guide
4

Water softener

estimate, confirm with a lab test

A softener is worth considering. The nearest monitoring well has a median hardness of 152.6 mg/L as CaCO₃.

Hard-water guide
5

UV disinfection

estimate, confirm with a lab test

UV disinfection is worth considering where wells draw from Unconsolidated. Test for coliform bacteria. This follows the aquifer type.

Bacteria and UV guide
Local Contractors

Licensed Water Well Drillers Serving Spallumcheen

Because water wells in Spallumcheen average 199 ft into unconsolidated, contractors equipped with heavy rotary rigs and proper casing seals are recommended. Contact local drillers directly or request competitive bids.

Aqua Source Drilling

Yard: Vernon, BC (19 km away)

Confirm the contractor's provincial licence before you hire
Okanagan Aquifers Deep Sand & Gravel Domestic Wells

Bud’s Water Wells Ltd.

Yard: Kamloops, BC (68.4 km away)

Confirm the contractor's provincial licence before you hire
Interior BC Bedrock Submersible Pumps Pressure Tanks

A & H Drilling Ltd.

Yard: Chilliwack, BC (238.7 km away)

Confirm the contractor's provincial licence before you hire
Dual Rotary Drilling Agricultural Irrigation Domestic Wells

JR Drilling

Yard: Cranbrook, BC (269 km away)

Confirm the contractor's provincial licence before you hire
Kootenay Mountain Bedrock Domestic Water Wells Artesian Flow Management

Looking for more regional well drillers?

Explore all registered water well contractors operating across BC.

Featured Contractor Spot

Are you a licensed well driller serving Spallumcheen?

Claim your verified listing profile and be found by homeowners on this report.

Claim Local Listing

Frequently Asked Questions

Quick answers about water wells in Spallumcheen.

What is the median well depth in Spallumcheen?

Among 137 producing water wells with a recorded depth, the median is 199.0 ft (60.66 m).

Which aquifer is recorded most often in Spallumcheen?

The most frequently recorded producing aquifer is Unconsolidated, on 44 of 57 wells with a producing aquifer name.

Adjacent Municipalities & Nearby Well Records

Explore neighbouring hydrogeological formations and compare drilling depths

Nearby communities